Installation kit and full fitting/operational instructions
For a full range of gas detection tubes see typically stock no
376-9875
SF340 Carbon Monoxide Detectors
The SF340 series of CO detectors are designed for fixed and permanent installations, officially approved and kite-marked to BS7860 - the British standard for domestic CO alarms.They incorporate a unique module replacement system
There are no re-wiring or main unit replacement costs - just a simple, clip-in module to change once every 5 years
This results in low ownership costs and minimal maintenance
Optional locking screws also ensure that only authorised persons can gain access to the unit
Battery backup - each unit offers up to 5 years battery backup for continuous protection, even in the event of power loss Uses advanced electrochemical sensing technology, specially developed for detection of CO at low concentration without being adversely affected by other gases, household agents or environmental changes Continuously monitors the environment for CO and provides an audible and visual alarm when concentration reaches 150ppm - the alarms continue if the gas remains at a dangerous level An internal diagnostic facility means the SF340 carries out continuous self-monitoring
If any fault is located in the sensor, battery or circuits, the unit will automatically give a warning signal within 60 seconds Complete 10 year guarantee on the main unit and a full 5 year guarantee on each sensor module Relay/interconnect option available, enabling connection to control panels, shut-off valves, remote alarms etc
This also allows numbers of alarms to be linked together in series
SF340E - 230V, 50Hz standard model SF340F - 230V, 50Hz relay output model （for relay and interconnect feature）
