Common connection of the supply rails may be achieved with pre-assembled jumper bars allowing the remaining termination to be used for the sensor signal lead
Non-indicating and indicating versions are available for both PNP and NPN sensors
Cable size and current rating is 2.5mm2 and 26 A for all types, with a mounting pitch of 6mm
Suitable for mounting on symmetric rail only （BS5584：1978）,Sub-type A ： 3 level feedthrough - use where space saving is a requisite.,Sub-type B ： 2 single contacts and a feedthrough, ideally suited for power distribution across a number of sensors using jumper bars, enabling the top feedthrough connection to be used for the signal lead.Sub-type C ： a three tier sensor terminal with red indication LED
Using the lower two terminations for power distribution, the upper feedthrough being used for the signal lead connection
The LED indicating sensor output suited to 24Vdc PNP output sensors.Sub-type D ： a three tier terminal, similar to the type 3, but suited to a 24Vdc NPN output sensor.Sub-type E ： a feedthrough terminal block with a green LED indicator to signify power on status
Suited to indicate signal/power conditions on PLCs
