This joystick is equipped with a dual axis giving you North, South, East and West control （X and Y axis）
It is sprung to centre and the use of 5 K potentiometers gives it a smooth, precise feel
Cost effective, industrial quality joystick Ideally suited for keyboard applications （CCTV, control panels etc） Low profile installation and ergonomic design 4mm solid stainless steel shaft with self centering mechanism Includes circular bezel and standard gaiter Temperature range -10 to +55°C 0.125W per potentiometer
Panel Mounting
It is panel mounted from beneath the panel and held in place with No
2 self-tapping counter-sunk screws
These screws are inserted from the top through the bezel
The length of the screws would depend on the thickness of the panel
Potentiometers
The 5000 series joysticks are fitted standard with 5 K potentiometers with a 220o track
The shaft deflection angle is a nominal 40o
A typical 5 V supply thus result in a full scale nominal deflection from 2 V to 3 V
Giving an operating nominal 2.5 V centre
These potentiometers are designed for use as a variable potentiometer divider, rather than a two-pin variable resistor
For optimum performance, the output signals ideally must be fed into a load of greater than 1000 K
This is due to noise generated by the contact resistance of the wiper to the track
Features ; Benefits
Cost effective, industrial quality joystick Ideally suited for keyboard applications （CCTV, control panels typically） Low profile installation and ergonomic design 4 mm solid stainless steel shaft with self-centring mechanism Includes circular bezel and standard gaiter Temperature range -10 to +55°C 0.125 W per potentiometer
Product Application Information
This joystick is ideally suited for use in applications where the installed depth is critical due to space restrictions
Including CCTV panels or keyboards but could extend to various other applications.
