The VNC2 debug module is designed to provide connectivity between the Vinculum-II IDE development software and the debug interface pin on the FTDI Vinculum-II （VNC2） USB host controller device
The VNC2 debug module consists of a miniature board with a USB miniB connector, which provides USB connectivity to Vinculum-II IDE development tools running on a PC
The VNC2 debug module can be used to program and debug firmware running on the VNC2 device
The module connects to the VNC2 device via a 6-way, 2mm pitch, keyed, female connector
The V2DIPx-x, VNC2 based development modules are equipped with a compatiblemAle connector to host the VNC2 debug module
Designers intending to use the module with their own VNC2 based hardware are required to have a similar compatiblemAle connector on their hardware
Details on the debug interface and connectors are outlined in subsequent sections of this document
One USB mini-B type socket to connect with a PC On-board FTDI FT232R which provides conversion from USB to serial interface for VNC2 debug port Low USB bandwidth consumption USB 2.0 Full Speed compatible UHCI/OHCI/EHCI host controller compatible +5V power output to V2DIP-x module （if needed） USB powered Programming and debugging for VNC2 IC designs Power and traffic indicator LEDs 6-way keyed connector to support FTDI s range of V2DIPx-x development modules -40 to +85℃ operating temperature range
